Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.04
RM2030EQ _56 Audio / Visual / Telematics _014659 NAVIGATION / MULTI INFO DISPLAY _0074553 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Cursor or Map Rotates when Vehicle Stopped  


PROCEDURE

1.CHECK CONDITION
a.
E106418

Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.


HINT:

If the vehicle is turned on a turntable with the engine switch turned on (ACC) or on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the engine switch off and back on (ACC) or on (IG) again with the vehicle completely stopped.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN THE ENGINE SWITCH ON (ACC) OR ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED