The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
Disconnect the I64 navigation receiver assembly connector.
Disconnect the I69 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I64-1 (FR+) - I69-5 (R+) | Always | Below 1 Ω |
| I64-5 (FR-) - I69-4 (R-) | Always | Below 1 Ω |
| I64-2 (FL+) - I69-3 (L+) | Always | Below 1 Ω |
| I64-6 (FL-) - I69-2 (L-) | Always | Below 1 Ω |
| I69-5 (R+) - Body ground | Always | 10 kΩ or higher |
| I69-4 (R-) - Body ground | Always | 10 kΩ or higher |
| I69-3 (L+) - Body ground | Always | 10 kΩ or higher |
| I69-2 (L-) - Body ground | Always | 10 kΩ or higher |
| I69-6 (SLD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG