The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.
Disconnect the I147 navigation receiver assembly connector.
Disconnect the I146 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below (for 6 Speakers).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I146-2 (UDO-) - I147-2 (US1-) | Always | Below 1 Ω |
| I146-3 (UDO+) - I147-3 (US1+) | Always | Below 1 Ω |
| I146-5 (UJSS) - I147-5 (USG1) | Always | Below 1 Ω |
| I146-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I146-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I146-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below (for 10 Speakers).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I146-2 (UDO-) - I147-2 (UDO-) | Always | Below 1 Ω |
| I146-3 (UDO+) - I147-3 (UDO+) | Always | Below 1 Ω |
| I146-5 (UJSS) - I147-5 (USG1) | Always | Below 1 Ω |
| I146-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I146-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I146-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG