Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47319F
3.SEPARATE REAR FLEXIBLE HOSE
Remove the union bolt and 2 gaskets, and separate the rear flexible hose from the rear disc brake cylinder assembly.
47850
4.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
| *a | Hold |
| *b | Turn |
Hold the rear disc brake cylinder slide pin, and remove the 2 bolts and rear disc brake cylinder assembly.
04466
5.REMOVE REAR DISC BRAKE PAD
Remove the 2 rear disc brake pads from the disc brake cylinder mounting.
47715C
6.REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 rear disc brake cylinder slide pins with rear disc brake bushing dust boot from the disc brake cylinder mounting.
47775D
7.REMOVE REAR DISC BRAKE BUSHING DUST BOOT
Remove the rear disc brake bushing dust boot from each rear disc brake cylinder slide pin.
47722A
8.REMOVE DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and disc brake cylinder mounting.
42491
9.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Remove the parking brake shoe adjusting hole plug.
42431
10.REMOVE REAR DISC
| *a | Matchmark |
Put matchmarks on the rear disc and the rear axle hub.
Release the parking brake and remove the rear disc.
If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.