Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR › from 2015.04
RM2030EQ _55 Steering _014657 STEERING GEAR / LINKAGE _0074538 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45470 1.INSPECT TIE ROD ASSEMBLY

a.
C132329

Secure the tie rod assembly in a vise.

NOTICE:

Do not overtighten the vise.



b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times.


d.

Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

Standard Turning Torque:

1.0 to 4.0 N*m (10 to 40 kgf*cm, 9 to 35 in.*lbf)


HINT:

If the turning torque is not within the specified range, replace the tie rod assembly.



Hide 2.INSPECT TOTAL PRELOAD

NOTICE:

Inspect the total preload in a no-load condition by removing the tie rod assembly RH and LH, and steering rack boots.


a.
C239563N01
2.635,1.01 3.063,1.01 3.063,1.01 3.063,1.396 false 2.927,1.396 3.24,1.552 0.313,0.156 10 SST

Install SST to the pinion shaft and turn it left and right 5 times or more.

SST
09616-00020  


b.

Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

Standard Preload
Lock to Lock Specified Value
3.12 rev. 0.7 to 1.2 N*m (8 to 12 kgf*cm, 7 to 10 in.*lbf)
2.85 rev. 0.7 to 1.3 N*m (8 to 13 kgf*cm, 7 to 11 in.*lbf)

NOTICE:

Inspect the total preload around the steering rack center position.


HINT:

If the total preload is not within the specified range, replace the steering gear assembly with a new one.