Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2015.04–2016.05
RM2030EQ _58 Vehicle Interior _014667 METER / GAUGE / DISPLAY _0074615 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83100 1.INSPECT COMBINATION METER ASSEMBLY

a.

INSPECT SPEEDOMETER

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.

·

Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Before starting the following inspection, check if the vehicle stability control system outputs the DTCs.


ii.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
Reference:
GTS Indication (km/h) Acceptable Range (km/h)
20 20.7 to 24.7
40 41.4 to 45.9
60 62.1 to 66.6
80 82.8 to 87.8
100 103.4 to 107.4
120 124.1 to 129.1
140 144.8 to 149.8
160 165.5 to 170.5
180 186.2 to 191.2
200 206.9 to 211.9
220 227.6 to 232.6



b.

INSPECT TACHOMETER

i.

Connect the GTS, and start the engine.


ii.

Compare the test results with the tachometer indications.

Reference:
GTS Indication (rpm) Acceptable Range
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)
7000 6700 to 7300



c.

CHECK LED ILLUMINATION (BULB CHECK)

i.

Check the illumination function of the warning or indicator lights listed below when turning the engine switch on (IG).

OK:
Warning or Indicator Light Specified Condition
Brake warning light Warning or indicator light comes on for about 3 seconds after turning the engine switch on (IG).
Slip indicator light
ABS warning light
VSC OFF indicator light
Eco driving indicator light
Master warning light Warning light comes on for about 3 seconds after turning the engine switch on (IG).
SRS warning light Warning light comes on for about 6 seconds after turning the engine switch on (IG).
MIL (Check engine warning light) Warning light comes on when turning the engine switch on (IG).
EPS warning light