Home › General › SPECIFICATIONS › 2GR-FE STARTING › from 2015.04
RM2030EQ _V1 General _014632 SPECIFICATIONS _0074348 2GR-FE STARTING F

SPECIFICATIONS  2GR-FE STARTING  SERVICE DATA  


Starter assembly Standard current: 90 A or less at 11.5 V
Starter magnetic switch assembly Standard resistance
50 - C: Below 1 Ω
50 - Body: Below 1 Ω
Starter armature assembly Standard resistance
Commutator: Below 1 Ω
Commutator - Coil core: 10 kΩ or higher
Standard length: 3.1 mm (0.122 in.)
Maximum length: 3.8 mm (0.150 in.)
Starter commutator end frame Standard length: 9.0 mm (0.354 in.)
Minimum length: 4.0 mm (0.157 in.)
Standard resistance
Positive (+) - Negative (-): 10 kΩ or higher
Snap ring Maximum length: 5.0 mm (0.196 in.)
Starter relay 3 - 5: 10 kΩ or higher (when battery voltage not applied between terminals 1 and 2)
3 - 5: Below 1 Ω (when battery voltage applied between terminals 1 and 2)
Engine switch 5 (SS1) - 6 (GND) / 1 (SS2) - 6 (GND)
Specified resistance
Not pushed: 10kΩ or higher
Pushed: Below 1 Ω
Standard condition: Illuminates
Measurement condition
Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (GND)