This circuit is from the parking brake switch assembly to the radio and display receiver assembly.
Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.
The brake warning light operates as specified above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I155 radio and display receiver assembly connector.
Disconnect the A42 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I155-15 (PKB) - A42-1 | Always | Below 1 Ω |
| I55-15 (PKB) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG