Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2015.04
RM2030EQ _56 Audio / Visual / Telematics _014658 AUDIO / VIDEO _0076716 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM

E265477E21
4.979,1.99 5.438,2.188 0.458,0.198 10 false I155 4.979,2.177 6.677,2.625 1.698,0.448 10 false Radio and Display Receiver Assembly 5.396,1.104 5.854,1.302 0.458,0.198 10 false REV 5.24,0.969 5.698,1.167 0.458,0.198 10 false 2 0.479,1.094 2.563,1.448 2.083,0.354 10 false from Park/Neutral Position Switch Assembly

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Check that the back-up light comes on.

OK:

The back-up light comes on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the I155 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I155-2 (REV) - Body ground Ignition switch ON
Shift lever in R
11 to 14 V
I155-2 (REV) - Body ground Ignition switch ON
Shift lever not in R
Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR