47547C
1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
Fully tighten the rear disc brake bleeder plug after bleeding the system.
31478C
2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
3.INSTALL PISTON SEAL
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
Install the piston seal to the rear disc brake cylinder.
Securely install the piston seal to the groove of the rear disc brake cylinder.
4.INSTALL CYLINDER BOOT
| *1 | Cylinder Boot |
| *2 | Rear Disc Brake Piston |
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot and rear disc brake piston.
Install the cylinder boot to the rear disc brake piston.
47731B
5.INSTALL REAR DISC BRAKE PISTON
| *1 | Cylinder Boot |
| *2 | Rear Disc Brake Piston |
Install the cylinder boot securely to the grooves of the rear disc brake cylinder.
Securely install the cylinder boot into the groove of the disc brake cylinder and rear disc brake piston.
Do not damage the cylinder boot.
Push in the piston by hand and install the boot onto the grooves of the piston.