AUTOMATIC LIGHT CONTROL SYSTEM
When the light control switch is in the AUTO position, the automatic light control system detects ambient light levels and controls the low beam headlights, clearance lights, taillights and license plate lights.
LIGHT AUTO TURN-OFF SYSTEM
General
The light auto turn-off system is used to prevent the exterior lights from being accidentally left on (headlights, front fog lights*1, taillights, clearance lights, license plate lights and rear fog lights*2).
When all of the following conditions are met, the headlights, front fog lights*1, taillights, clearance lights, license plate lights and rear fog lights*2 turn off:
The engine switch is turned from on (IG) to off.
The headlights, front fog lights*1, taillights, clearance lights, license plate lights and rear fog lights*2 are on.
The driver door is opened.
*1: w/ Front Fog Light
*2: w/ Rear Fog Light
LED HEADLIGHT SYSTEM
General
LED headlights are used to provide efficient, maintenance free lighting. Compared to halogen or HID headlights, even if an LED headlight is used for a long time, the reduction of brightness over its lifetime is less. In addition, there is no possibility of an LED having an open circuit due to vibration.
Function of Main Components
| Component | Outline | |
|---|---|---|
| Light Control ECU | ·
Turns on the LEDs immediately when the light control switch is turned to the head position. ·
Regulates the output current flowing into the LEDs at a specified level to prevent the light from getting brighter and dimmer due to voltage variation. ·
Transmits fail signals to the main body ECU (multiplex network body ECU) when a malfunction occurs in the LED headlight system. |
|
| Combination Meter Assembly | Master Warning Light | Flashes to inform the driver when the light control ECU detects a malfunction in this system. |
| Multi-information Display | Displays a warning message to inform the driver when the light control ECU detects a malfunction in this system. | |
| Main Body ECU (Multiplex Network Body ECU) | ·
Receives fail signals from the light control ECU when a malfunction occurs in the LED headlight system, and transmits the signals to the combination meter assembly. ·
Stores Diagnostic Trouble Codes (DTCs) when the system malfunctions. |
|