1.INSPECT REAR LIGHT ASSEMBLY LH (w/o Rear Fog Light)
| *a | Front view of wire harness connector
(to Rear Light Assembly LH) |
Disconnect the connector from the rear light assembly LH.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T20-2 (B)- T20-1 (E) | Engine started and the shift lever not in R | Below 1 V |
| Engine started and the shift lever in R | 11 to 14 V |
If the result is not as specified, repair or replace the wire harness or connector.
2.INSPECT REAR LIGHT ASSEMBLY RH (w/o Rear Fog Light)
| *a | Front view of wire harness connector
(to Rear Light Assembly RH) |
Disconnect the connector from the rear light assembly RH.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T19-2 (B)- T19-1 (E) | Engine started and the shift lever not in R | Below 1 V |
| Engine started and the shift lever in R | 11 to 14 V |
If the result is not as specified, repair or replace the wire harness or connector.
81591B
3.INSPECT REAR LIGHT ASSEMBLY LH (w/ Rear Fog Light)
| *a | Front view of wire harness connector
(to Rear Light Assembly LH) |
Disconnect the connector from the rear light assembly LH.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T27-1 (B) - T27-3 (E) | Engine started and the shift lever not in R | Below 1 V |
| Engine started and the shift lever in R | 11 to 14 V | |
| T27-2 (B) - T27-3 (E) | Light control switch off | Below 1 V |
| Light control switch in tail position | 11 to 14 V | |
| T27-4 (B) - T27-3 (E) | Light control switch in tail position, rear fog light switch off | Below 1 V |
| Light control switch in tail position, rear fog light switch on | 11 to 14 V |
If the result is not as specified, repair or replace the wire harness or connector.
81581C
4.INSPECT REAR LIGHT ASSEMBLY RH (w/ Rear Fog Light)
| *a | Front view of wire harness connector
(to Rear Light Assembly RH) |
Disconnect the connector from the rear light assembly RH.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T26-1 (B) - T26-3 (E) | Engine started and the shift lever not in R | Below 1 V |
| Engine started and the shift lever in R | 11 to 14 V | |
| T26-2 (B) - T26-3 (E) | Light control switch off | Below 1 V |
| Light control switch in tail position | 11 to 14 V | |
| T26-4 (B) - T26-3 (E) | Light control switch in tail position, rear fog light switch off | Below 1 V |
| Light control switch in tail position, rear fog light switch on | 11 to 14 V |
If the result is not as specified, repair or replace the wire harness or connector.