CONSTRUCTION
The non-contact type accelerator pedal sensor assembly uses a Hall IC.
A magnetic yoke is mounted at the base of the accelerator pedal arm. This yoke rotates around the Hall IC in accordance with the amount of effort that is applied to the accelerator pedal. The Hall IC converts the changes in the magnetic flux that occur into electrical signals, and outputs accelerator pedal position signals to the power management control ECU.
The Hall IC contains 2 circuits, one for the main signal, and one for the sub signal. It converts the accelerator pedal position (angle) into electric signals that have differing characteristics and outputs them to the power management control ECU.
| *1 | Hall IC | *2 | Magnetic Yoke |
| *3 | Accelerator Pedal Arm | - | - |