SYSTEM CONTROL
Hill-start Assist Control
When the vehicle starts off on a steep or slippery hill, the vehicle could descend backward while the driver switches from the brake pedal to the accelerator pedal, thus making it difficult for the vehicle to start off. To prevent this from occurring, the Hill-start Assist Control temporarily (approximately 2 seconds at the maximum) applies the brakes to all the wheels in order to prevent the vehicle from descending backward.
Without the Hill-start Assist Control, the driver must quickly and precisely switch from the brake pedal to the accelerator pedal. With the Hill-start Assist Control, however, the driver can start off easily and operate the pedal in a relaxed manner because the Hill-start Assist Control prevents the vehicle from descending backward.
Operating Condition
The skid control ECU starts Hill-start Assist Control operation when the operating conditions below are met and the driver further depresses the brake pedal, causing the hydraulic pressure to exceed the control-start hydraulic pressure.
When Hill-start Assist Control operation starts, the buzzer in the combination meter assembly will sound once.
| Hill-start Assist Control Operation Condition | ·
The shift position is in any position other than P. ·
The accelerator pedal is not depressed. ·
The vehicle is at a standstill. ·
The parking brake is not applied. |
If any one of the below conditions is met during Hill-start Assist Control operation, Hill-start Assist Control will be canceled causing the slip indicator light to turn off.
The buzzer in the combination meter assembly sounds twice if the Hill-start Assist control is cancelled.
| Conditions which cause Hill-start Assist Control operation to be canceled | a) Buzzer in combination meter assembly does not sound | ·
The driver depresses the accelerator pedal. |
| b) Buzzer in combination meter assembly sounds twice | ·
The driver changes the shift position to P. ·
The driver depresses the parking brake pedal. ·
The driver depresses the brake pedal. ·
The driver releases the brake pedal for several seconds. ·
The driver keeps the brake pedal depressed continually for 3 minutes. |