FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Rear Television Camera Assembly | ·
Captures images of the area behind the vehicle. ·
The parking assist guide lines that are calculated based on signals from the steering sensor are superimposed on the captured image. Then, the image is sent to the navigation receiver assembly as video signals. ·
When the luggage compartment door is open, superimposing of parking assist guide lines is canceled and only the captured image is sent as video signals. |
| Navigation Receiver Assembly | ·
Receives visual signals composed of the area behind the vehicle with parking assist guide lines overlaid from the rear television camera assembly, and displays them. ·
Sends signals indicating a mode change in parking guide line display functions to the rear television camera assembly. |
| Steering Sensor | Detects the angle of the steering wheel and sends the resulting signals to the rear television camera assembly. |
| Power Management Control ECU | Sends an R shift position signals to the rear television camera assembly. |
| Luggage Compartment Door Lock Assembly
·
Luggage Compartment Door Courtesy Switch |
Sends the luggage compartment door courtesy switch signal to the main body ECU (multiplex network body ECU). |
| Main Body ECU (Multiplex Network Body ECU) | Sends the luggage compartment door courtesy switch signal to the rear television camera assembly. |
| Brake Booster with Master Cylinder Assembly
·
Skid Control ECU |
Sends a vehicle speed signal to the rear television camera assembly. |
| Power Steering ECU Assembly | Sends a steering type information signal to the rear television camera assembly. |
| Component | Function |
|---|---|
| Rear Television Camera Assembly | Captures images of the area behind the vehicle and outputs video signals to the navigation receiver assembly. |
| Navigation Receiver Assembly | Displays images of the area behind the vehicle sent from the rear television camera assembly using the multi display. The image is combined with the parking assist guide lines that are calculated based on signals from the steering sensor. |
| Power Management Control ECU | Sends an R shift position signal to the engine room junction block assembly. |
| Engine Room Junction Block Assembly | Sends an R shift position signal to the navigation receiver assembly. |
| Steering Sensor | Detects the angle of the steering wheel and sends the resulting signals to the navigation receiver assembly. |
| Combination Meter Assembly | Transmits the vehicle speed signal to the navigation receiver assembly. |
| Luggage Compartment Door Lock Assembly
·
Luggage Compartment Door Courtesy Switch |
Sends the luggage compartment door courtesy switch signal to the navigation receiver assembly via the main body ECU (multiplex network body ECU). |
SYSTEM CONTROL
The parking assist monitor system operates when both of the following conditions are met:
Power switch is on (IG).
Shift lever in R.
FUNCTION
Area Displayed on Screen
Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.
The rear television camera uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.
| *a | The illustration shown is an example only. The illustration may differ from the actual vehicle screen. | - | - |
The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.
Warning Message
A warning message appears at the bottom or center of the screen under the following conditions. The warning message appears in the same language that has been selected by the language selector of the multi-display.
| Warning Message | Condition |
|---|---|
|
*: Models with parallel parking assist mode |
|
| Check surroundings for safety. | This message always appears during system operation. |
| System initializing.* | This message appears when the steering wheel is operated while the battery terminal (-) is disconnected and then is reconnected. |
| Guidance is unavailable.* | This message appears if there is a malfunction in this system. |
| Warning Message | Condition |
|---|---|
|
*: Models with parallel parking assist mode |
|
| System not ready.* | This message appears if the system is not initialized. |
Calibration Following Parts Replacement
The items listed below must always be adjusted whenever one of the following conditions occurs. For details, refer to the Repair Manual.
| Adjustment Items | Condition |
|---|---|
|
*1: Models without parallel parking assist mode *2: Models with parallel parking assist mode |
|
| Neutral steering point in memory | ·
Estimated course lines are not displyed.*1 ·
System initializing is displayed.*2 |
| Steering angle setting | ·
After steering sensor is removed and installed or after connector is disconnected and reconnected, system initializing is displayed.*2 ·
Steering sensor replacement. |
| Camera optical axis adjustment | ·
Vehicle height has changed due to replacement of suspension parts or tires. ·
The installation angle of the rear television camera assembly has changed. |
| Parking assist monitor system initialization | Rear television camera assembly*1 or navigation receiver assembly*2 is replaced. |
FAIL-SAFE
The table below indicates the malfunction detection items for the components in this system.
| Malfunction Parts | Detection Item | Function |
|---|---|---|
| Steering Sensor | ·
Sensor malfunction signal is detected ·
Sensor open circuit signal is detected ·
Communication malfunction between the steering sensor and rear television camera assembly |
Stops system operation |
| Neutral steering point correction incomplete signal is detecte | ||
| Rear Television Camera Assembly | Camera malfunction signal is detected | Stops signal reception and displays a dark screen |
| Malfunction Parts | Detection Item | Function |
|---|---|---|
| Steering Sensor | ·
Sensor malfunction signal is detected ·
Sensor open circuit signal is detected ·
Communication malfunction between the steering sensor and navigation receiver assembly |
Displays "Guidance is unavailable" |
| Neutral steering point correction incomplete signal is detecte | Displays "System initializing" | |
| Rear Television Camera Assembly | Camera malfunction signal is detected | Stops signal reception and displays a dark screen |
| Navigation Receiver Assembly | Malfunction of navigation receiver assembly | Stops system operation |
DIAGNOSIS
The navigation receiver assembly is equipped with a diagnosis function which can display a diagnosis menu for the parking assist monitor system. The method for entering the diagnosis menu screen is the same as the method used for the multi-display. For details, refer to the Repair Manual.