SYSTEM CONTROL
The states of the theft deterrent system are as follows:
| State | Description | Theft Detection |
|---|---|---|
| Disarmed State | The theft deterrent system has not been set by the user. | Not possible |
| Armed Preparation State | This is the preparation state before the theft deterrent system becomes active (enters the armed state) when the system has been set by the user. | Not possible |
| Armed State | The theft deterrent system is active. (Theft can be detected.) | Possible |
| Alarm State | A theft attempt has been detected and the warning operation activates. | Possible |
The theft deterrent system activates as shown in the diagram above when one of the items in the table occurs in order to cause the system to enter the respective state.
| Condition | Item |
|---|---|
| (1) | In disarmed state 1, when the power switch is off, the system state is switched if the following condition is met:
·
With the doors, the engine hood and luggage compartment door closed, all doors are locked by wireless operation, the smart entry and start system or key linked power door lock operation. In disarmed state 1, when the power switch is off, the engine hood and luggage compartment door are closed, and all doors are locked, the system state is switched if the following condition is met: ·
All doors are closed (when any door was previously opened). |
| (2) | Approximately 30 seconds elapse. |
| (3) | ·
The doors are unlocked by wireless operation, the smart entry and start system or key linked power door lock operation. ·
Any door is unlocked. ·
Any door is opened. ·
The power switch is pushed. ·
The battery is reconnected. |
| (4) | ·
The engine hood is opened. ·
The luggage compartment door is opened. ·
The battery is reconnected. ·
Any door is opened. ·
Any door is unlocked. ·
When 5 seconds or more have elapsed after the power switch is pushed, the power source mode changes to on (IG). |
| (5) | ·
The power switch is turned on (READY). ·
All doors are unlocked by wireless operation, the smart entry and start system or key linked power door lock operation. ·
The power source mode changes to on (ACC) or on (IG) within 5 seconds after the power switch is pushed. |
| (6) | After approximately 27.5 seconds, the alarm stops and the system returns to the armed state. |
| (7) | The luggage compartment door is opened by wireless operation or the smart entry and start system. |
| (8) | ·
The luggage compartment door is open → closed (the engine hood is already closed). ·
The engine hood is open → closed (the luggage compartment door is already closed). |
| (9) | ·
Any door is unlocked. ·
Any door is opened. ·
The power switch is pushed. ·
The battery is reconnected. ·
All doors are unlocked by wireless operation, the smart entry and start system or key linked power door lock operation. ·
The power source mode changes to on (ACC) or on (IG). |
| (10) | In disarmed state 1, when the power switch is off, the system state is switched if the following condition is met:
·
With all doors closed, and the engine hood and luggage compartment door opened, all doors are locked by wireless operation, the smart entry and start system or key linked power door lock operation. In disarmed state 1, when the power switch is off, all doors are locked and the engine hood and luggage compartment door are open, the system state is switched if the following condition is met: ·
All doors are closed (when any door was previously opened). |
| (11) | ·
The engine hood is opened. ·
The luggage compartment door is opened by wireless operation or the smart entry and start system. |
FUNCTION
The theft deterrent system has the following functions:
| Function | Outline |
|---|---|
| Alarm | When the theft deterrent system switches to the alarm state, the warning items are operated and the alarm sounds for approximately 27.5 seconds. |
| Alarm Indicator | When the theft deterrent system switches to the armed preparation state or alarm state, the security indicator light is illuminated to inform the user. This indicator is also the engine immobiliser indicator, which blinks when the engine immobiliser is in the set state. |
| Forced Door Lock | The main body ECU (multiplex network body ECU) transmits a door lock signal to all the doors when all the following conditions are met:
·
The theft deterrent system is in the alarm state. ·
One of the doors has been unlocked. The function stops when one of the following conditions is met: ·
All doors are locked. ·
The warning ends after approximately 27.5 seconds. ·
The electrical key transmitter sub-assembly is in the actuation area. |