FUNCTION OF MAIN COMPONENTS
The raindrop sensing function consists of the following parts:
| Component | Function |
|---|---|
|
*: Models with rain sensing function |
|
| Wiper Switch (Windshield Wiper Switch Assembly) | ·
Outputs the position signal of the wiper switch (windshield wiper switch assembly) to the windshield wiper motor assembly, windshield washer motor and pump assembly and windshield wiper relay assembly*. ·
Setting this switch to AUTO will cause the rain sensing function to operate. This switch is also used to adjust the rain sensing function sensitivity.* |
| Wiper Motor and Link Assembly | Activates the front wiper in accordance with the position signal of the wiper switch (windshield wiper switch assembly) or the control signal from the windshield wiper relay assembly. |
| Windshield Washer Motor and Pump Assembly | Activates in accordance with the signal from the washer switch (windshield wiper switch assembly). |
| Rain Sensor* | Senses rain when the wiper switch (windshield wiper switch assembly) is in AUTO, and sends signals to the windshield wiper relay assembly. |
| Windshield Wiper Relay Assembly* | Receives the operation signal from the wiper switch (windshield wiper switch assembly) and the rain sensor, and inputs them into the windshield wiper motor assembly. |
| Combination Meter Assembly | Outputs the vehicle speed signal to the windshield wiper relay assembly.* |
FUNCTION
Rain Sensing Function
The rain sensing function controls the wiping timing in accordance with the amount of raindrops when the wiper switch (windshield wiper switch assembly) is in the AUTO position.
This control is effected by the rain sensor based on the amount of raindrops and input signals from the windshield wiper relay assembly.
A luminance detection function is provided to automatically change the raindrop sensitivity according to day or night.
Washer-linked Wiper Function
When the wiper switch (windshield wiper switch assembly) is in the off or AUTO position and the washer switch (windshield wiper switch assembly) is turned on for approximately 0.5 seconds or more, the wipers start on LO at the same time as the washer fluid is sprayed.
FAIL-SAFE
If the windshield wiper relay assembly detects a malfunction of the rain sensor during the operation of the rain sensing function, the following controls will be performed:
Continuously performs wiper operation prior to the occurrence of a malfunction.
Switches to intermittent operation if a malfunction of the rain sensor is detected when the power switch is turned from off to on (IG) or the wiper switch (windshield wiper switch assembly) is in the AUTO position.