CONSTRUCTION
The following body structures are used in order to reduce panel vibration and body frame movement.
| Panel Vibration Reduction Structure | ·
The cross member of the dash panel is provided ·
The tunnel reinforcement is connected to the floor |
| *1 | Cross Member of Dash Panel | *2 | Tunnel Reinforcement |
| *3 | Floor Pan Panel | *4 | Bead |
Asphalt sheets are applied to the floor in order to reduce noise in the cabin.
|
Asphalt Sheet | - | - |
Silencer pads are provided on the engine compartment side and cabin side of the dash panel, minimizing penetration of engine noise and road noise into the cabin.
| *1 | Dash Panel Insulator Outer | *2 | Dash Panel |
| *3 | Dash Panel Insulator Inner | - | - |
The layout of the sound-absorbing material is optimized to reduce noise and vibration.
| *a | A-A Cross Section | *b | B-B Cross Section |
| *c | C-C Cross Section | - | - |
|
Sound-absorbing Material | - | - |
Silencers are provided inside the rear wheel housings to minimize the penetration of splashing noise generated in the wheel housings into the cabin.
| *1 | Rear Wheel House Silencer | - | - |
| *a | A-A Cross Section | - | - |
Weatherstrips are provided for the front and rear doors at the rocker panel to minimize the penetration of road noise into the cabin.
| *1 | Weatherstrip | - | - |
| *a | A-A Cross Section | - | - |