FUNCTION
Buzzer Function
The table below shows the warning and reminder functions of the buzzer in the combination meter assembly.
|
*1: Models with lane departure alert system *2: Models with dynamic radar cruise control system |
|||
| 1 | READY | 2 | Seat Belt Warning (Level 2) |
| 3 | Rear Passenger Side Seat Belt Warning | 4 | Seat Belt Warning (Level 1) |
| 5 | Brake Force Reduction System | 6 | EPS Warning |
| 7 | Lane Departure Alert Warning*1 | 8 | Smart Entry and Start System Warning (Continuous) |
| 9 | Smart Entry and Start System Warning (Intermittent) | 10 | Brake System Temperature Rise or Active Test |
| 11 | Smart Entry and Start System Warning (Continuous, maximum 9 times) | 12 | Smart Entry and Start System Warning (Once) |
| 13 | Multi-information Display Warning | 14 | Accelerator Depression in N Position |
| 15 | Hybrid System Check (Intermittent) | 16 | HV Battery Low Warning (SOC: 25% or less) |
| 17 | Hybrid System Check (Once) | 18 | HV Battery Low Warning (SOC: 18% or less) |
| 19 | Dynamic Radar Cruise Control Cancellation due to Low Speed Warning*2 | 20 | Immobiliser Certification Reminder |
| 21 | Shift Position P Request | 22 | Parking Brake Engaged Warning |
| 23 | Door Open while Driving Warning | 24 | EV Mode Reject Warning |
| 25 | Turn Signal/Hazard Warning Operation | - | - |
Multi-information Display
Display Function Flow
The multi-information display can be switched as shown in the flow chart below:
| No. | Display Change Condition |
|---|---|
| *a | Conditions are met. |
| *b | Conditions are not met. |
| *c | If there are multiple display requests, items will be displayed in sequence. |
| *d | An item or display is selected by operating the steering pad switch assembly. |
| *e | After power switch on (IG). |
| *f | The Eco Drive Level (ending) display is displayed for a certain period of time after the power switch is turned off. |
Information Display Tab Operation
The information currently displayed can be switched using the RIGHT (PAGE) switch of the steering pad switch assembly.
| *A | Models with Navigation System | - | - |
| *1 | Steering Pad Switch Assembly | *2 | RIGHT (PAGE) Switch |
| *3 | Drive Information | *4 | Navigation Information |
| *5 | Cruise Control System/Dynamic Radar Cruise Control System Information | *6 | Warning Message |
| *7 | Settings | - | - |
| *a | The illustrations shown are examples only. | - | - |
|
RIGHT (PAGE) switch operation | - | - |
Drive Information Mode Function
The drive information tab shows vehicle information such as drivable range and fuel consumption.
The drive information display can be changed by using the UP/DOWN switch of the steering pad switch assembly.
| *1 | Steering Pad Switch Assembly | *2 | UP Switch |
| *3 | DOWN Switch | *4 | Drive Information 1 |
| *5 | Drive Information 2 | *6 | Drive Information 3 |
| *7 | Energy Monitor | *8 | Blank |
| *a | The illustrations shown are examples only. | - | - |
|
DOWN switch operation |
|
UP switch operation |
Setting Function
The items displayed on the multi-information display can be customized.
The following items can be selected on the information setting screen.
| Item | Available Setting |
|---|---|
|
*: Models with Navigation System |
|
| Language | The language used on the multi-information display can be selected:
·
English (Default) ·
French ·
Spanish |
| Unit | The unit displayed on the multi-information display can be selected:
·
km (L/100 km) (Default) ·
km (km/L) |
| Drive Information 3 | 2 items can be selected among the following:
·
Total Average Vehicle Speed between Reset Operations (Default of lower area) ·
Average Vehicle Speed after Engine Start-up ·
Total Elapsed Time between Reset Operations ·
Elapsed Time after Engine Start-up ·
Cruising Range (Default of upper area) ·
Cruising Range after Engine Start-up ·
Total Cruising Range between Reset Operations ·
Blank |
| EV Driving Indicator Light | The EV Driving Indicator Light can be switched:
·
ON (Default) ·
OFF |
| Interruption Display | The following displays that appear as soon as the set conditions are met can be switched to ON (default) or OFF:
·
Turn-by-turn Navigation Display* ·
Incoming Telephone Display ·
Rheostat |
| Accent Color | The accent color can be changed:
·
Clear Blue (Default) ·
Clear Turquoise ·
Deep Orange ·
Radiant Orange |
| Initialization | The set items can be initialized. |
Warning Mode Function
When a warning is necessary, the warning display interrupts the current display on the multi-information display.
The master warning light may illuminate or blink and the buzzer in the combination meter assembly may sound depending on the item displayed on the multi-information display.
| Priority | Display | Master Warning Light | Buzzer |
|---|---|---|---|
|
*1: Models with lane departure alert system *2: Models with dynamic radar cruise control system *3: Models with pre-crash safety system *4: If the vehicle has reached a speed of 5 km/h (3 mph) *5: Models with TOYOTA Parking Assist-sensor System (4 Sensor Type) *6: Models with blind spot monitor system *7: Models with sliding roof system *8: Models with automatic high beam system |
|||
| 1 | Maintenance Mode | - | - |
| Certification Mode | - | - | |
| Adjusting LDA Camera*1 | - | - | |
| Adjusting Front Radar Beam*2 | - | - | |
| Checking Cruise Control C/D*2 | - | - | |
| Checking Cruise Control Brake*2 | - | - | |
| BRAKE!*3 | - | - | |
| 2 | Lane departure alert warning reminder indicator (image display)*1 | - | - |
| Dynamic radar cruise control warning reminder indicator (image display)*2 | - | - | |
| Shift to P position when parked | Blinks | Sounds | |
| 3 | Door open (while driving) (image display)*4 | Blinks | Sounds |
| Door open (image display) | - | - | |
| Clearance sonar detection (image display)*5 | - | - | |
| Check Park Sonar System*5 | Illuminates | - | |
| Clean Park Sonar*5 | Illuminates | - | |
| 4 | Auto Power OFF to Conserve Battery | - | - |
| 5 | Shift to P position when parked | Blinks | Sounds |
| N position | Blinks | Sounds | |
| Traction battery preservation mode
Restart after shifting to P position |
Blinks | Sounds | |
| 6 | Check Hybrid System
Stop the vehicle in a safe place immediately |
Illuminates | Sounds |
| Traction battery Low
Charges when not in N position |
Blinks | Sounds | |
| Release Parking Brake | Blinks | Sounds | |
| Key not detected | Blinks | Sounds | |
| 7 | Charging System Malfunction
See Owner's Manual |
- | - |
| Clean Radar Sensor*2 | Illuminates | Sounds | |
| Cruise Control not available*2 | Illuminates | Sounds | |
| LDA not available*1 | Illuminates | Sounds | |
| Check Entry & Start System | Blinks | Sounds | |
| BSM not available*6 | Illuminates | Sounds | |
| Check Cruise Control System | Illuminates | Sounds | |
| Check LDA System*1 | Illuminates | Sounds | |
| Check PCS System*3 | Illuminates | Sounds | |
| Check BSM System*6 | Illuminates | Sounds | |
| Engine Oil Pressure Low | Illuminates | Sounds | |
| LDA System is Unavailable Below Approx. 50 km/h*1 | - | - | |
| LDA System is Unavailable at this Speed*1 | - | - | |
| 8 | Lane departure alert indicator (image display)*1 | - | - |
| Dynamic radar cruise control indicator (image display)*2 | - | - | |
| Pre-crash safety system alert (image display)*3 | - | - | |
| Pre-crash Safety Turned Off*3 | - | - | |
| Turn Power OFF | Blinks | Sounds | |
| Key detected in vehicle | Blinks | Sounds | |
| Moon Roof opened*7 | Blinks | Sounds | |
| Depress brake pedal, touch POWER switch with key | Blinks | Sounds | |
| Depress brake pedal and push POWER switch to start | Blinks | Sounds | |
| Shift to P position to start | Blinks | Sounds | |
| 9 | Steering Lock active | Blinks | Sounds |
| Shift to P position to start | Blinks | Sounds | |
| 10 | Key Battery Low | Illuminates | Sounds |
| Hybrid System Overheat
Output Power is limited |
Illuminates | Sounds | |
| Check Headlight System*8 | Illuminates | Sounds | |
| 11 | Driving force Limited | - | - |
| Cooling performance of the hybrid battery is low
Consult a dealer |
- | - | |
| Low 12-volt Battery
See Owner's Manual |
- | - | |
| Fuel Low | - | - | |
| TRC OFF | - | - | |
| Power ON | - | - | |
| Depress brake pedal and push POWER switch to start | - | - | |
| Pre-Crash Brake is disabled due to VSC OFF*3 | - | - | |
| PCS temporarily not available*3 | - | - | |
| EV mode currently not available | - | Sounds | |
| EV mode not available
Warming up |
- | Sounds | |
| EV mode currently not available
Low battery |
- | Sounds | |
| EV mode currently not available
Excessive speed |
- | Sounds | |
| EV mode currently not available
Excessive acceleration |
- | Sounds | |
| EV mode deactivated | - | Sounds | |
| EV mode deactivated
Low battery |
- | Sounds | |
| EV mode deactivated
Excessive speed |
- | Sounds | |
| EV mode deactivated
Excessive acceleration |
- | Sounds | |
OPERATION
Hybrid System Indicator Operation
The Hybrid System Indicator will begin to operate when both of the following conditions are met:
The hybrid system is operating (the READY indicator light is illuminated).
The shift position is not in P, R or N.
Eco Drive Level
The eco drive level changes among 5 levels to indicate the average fuel consumption and current fuel consumption.
After the power switch is turned off, the eco drive level display appears for 3 seconds in the multi-information display. When the average fuel consumption is 5.6 L/100 km or less or 18 km/L or higher, the "EXCELLENT!" message flashes.
| Average Fuel Consumption Level | Multi-information Display |
|---|---|
| Level 0
(9 L/100 km or higher) |
|
| Level 1
(8 to 9 L/100 km) |
|
| Level 2
(7 to 8 L/100 km) |
|
| Level 3
(6 to 7 L/100 km) |
|
| Level 4
(5 to 6 L/100 km) |
|
| Level 5
(5 L/100 km or less) |
|
| EXCELLENT!
(5.6 L/100 km or less) |
|
| Average Fuel Consumption Level | Multi-information Display |
|---|---|
| Level 0
(5 km/L or less) |
|
| Level 1
(5 to 7.5 km/L) |
|
| Level 2
(7.5 to 10 km/L) |
|
| Level 3
(10 to 12.5 km/L) |
|
| Level 4
(12.5 to 15 km/L) |
|
| Level 5
(15 km/L or higher) |
|
| EXCELLENT!
(18 km/L or higher) |
|