Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2015.04
NM2040EQ _56 Audio / Visual / Telematics _014506 PARK ASSIST / MONITORING _0073606 PARKING ASSIST MONITOR SYSTEM CO CONTROL F

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  CONTROL  PARKING ASSIST MONITOR CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Rear Television Camera Assembly
·

Captures images of the area behind the vehicle.

·

The parking assist guide lines that are calculated based on signals from the steering sensor are superimposed on the captured image. Then, the image is sent to the navigation receiver assembly as video signals.

·

When the luggage compartment door is open, superimposing of parking assist guide lines is canceled and only the captured image is sent as video signals.


Navigation Receiver Assembly
·

Receives visual signals composed of the area behind the vehicle with parking assist guide lines overlaid from the rear television camera assembly, and displays them.

·

Sends signals indicating a mode change in parking guide line display functions to the rear television camera assembly.


Steering Sensor Detects the angle of the steering wheel and sends the resulting signals to the rear television camera assembly.
Power Management Control ECU Sends an R shift position signals to the rear television camera assembly.
Luggage Compartment Door Lock Assembly
·

Luggage Compartment Door Courtesy Switch


Sends the luggage compartment door courtesy switch signal to the main body ECU (multiplex network body ECU).
Main Body ECU (Multiplex Network Body ECU) Sends the luggage compartment door courtesy switch signal to the rear television camera assembly.
Brake Booster with Master Cylinder Assembly
·

Skid Control ECU


Sends a vehicle speed signal to the rear television camera assembly.
Power Steering ECU Assembly Sends a steering type information signal to the rear television camera assembly.
Clearance Warning ECU Assembly Sends a clearance sonar information signal to the rear television camera assembly.


SYSTEM CONTROL


a.

The parking assist monitor system operates when both of the following conditions are met:

·

Power switch is on (IG).

·

Shift lever in R.




FUNCTION


a.

Area Displayed on Screen

i.

Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.


ii.

The rear television camera uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.

Y177200

NOTICE:

The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.




b.

Warning Message

i.

A warning message appears at the bottom of the screen under the following conditions. The warning message appears in the same language that has been selected by the language selector of the multi-display.

Message Appearing at Bottom of Screen
Warning Message Condition
Check surroundings for safety. This message always appears during system operation.



c.

Calibration Following Parts Replacement

i.

The items listed below must always be adjusted whenever one of the following conditions occurs. For details, refer to the Repair Manual.

Adjustment Items Condition
Neutral steering point in memory Estimated course lines are not displayed.
Steering angle setting
·

After steering sensor is removed and installed or after connector is disconnected and reconnected.

·

Steering sensor replacement.


Camera optical axis adjustment
·

Vehicle height has changed due to replacement of suspension parts or tires.

·

The installation angle of the rear television camera assembly has changed.


Parking assist monitor system initialization Rear television camera assembly is replaced.




FAIL-SAFE


a.

The table below indicates the malfunction detection items for the components in this system.

Malfunctioning Parts Detection Item Function
Rear Television Camera Assembly Camera malfunction signal is detected Stops signal reception and displays a dark screen
Steering Sensor
·

Sensor malfunction is detected

·

Sensor open circuit signal is detected

·

Communication malfunction between the steering sensor and rear televison camera assembly


Stops system operation
Neutral steering point correction incomplete signal is detected
Navigation Receiver Assembly Malfunction of navigation receiver assembly



DIAGNOSIS


a.

The navigation receiver assembly is equipped with a diagnosis function which can display a diagnosis menu for the parking assist monitor system. The method for entering the diagnosis menu screen is the same as the method used for the multi-display. For details, refer to the Repair Manual.