Home › General › SPECIFICATIONS › ALIGNMENT / HANDLING DIAGNOSIS
RM2040EQ _V1 General _014689 SPECIFICATIONS _0074831 ALIGNMENT / HANDLING DIAGNOSIS F

SPECIFICATIONS  ALIGNMENT / HANDLING DIAGNOSIS  SERVICE DATA  


Vehicle Height (Unloaded Vehicle)
Front A - B Rear C - D
124.4 mm (4.90 in.) 53.1 mm (2.09 in.)

Measurement points:

A: Ground clearance of front wheel center


B: Ground clearance of lower No. 2 suspension arm bushing set bolt center


C: Ground clearance of rear wheel center


D: Ground clearance of strut rod set bolt center


Camber (Unloaded Vehicle)
- Camber Inclination Right-left Difference
Front -0.69° +/- 0.75°(-0°41' +/- 45') 0.75°(0°45') or less
Rear -1.38° +/- 0.75°(-1°23' +/- 45') 0.75°(0°45') or less

Caster (Unloaded Vehicle)
- Caster Inclination Right-left Difference
Front 2.93° +/- 0.75°(2°56' +/- 45') 0.75°(0°45') or less

Steering Axis Inclination (Unloaded Vehicle)
- Steering Axis Inclination
Front 12.10°(12°06')

Toe-in (Unloaded Vehicle)
- Specified Condition
Front C + D: 0.02° +/- 0.17° (0°01' +/- 0°10')
B - A: 0.26 +/- 2.0 mm (0.0102 +/- 0.0787 in.)
Rear C + D: 0.35° +/- 0.17°(0°21' +/- 0°10')
B - A: 4.1 +/- 2.0 mm (0.161 +/- 0.0787 in.)

Wheel Turning Angle (Unloaded Vehicle)
- Inside Wheel Outside Wheel Reference
Front 38.60° +/- 2°(38°36' +/- 2°) 33.75°(33°45')