Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074873 CAMSHAFT OIL CONTROL VALVE G

2AR-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the oil control valve assembly.


b.
A255142
0.781,1.417 0.99,1.865 0.99,1.865 1.208,1.865 false 1.25,1.771 1.563,1.927 0.313,0.156 10 *1 2.667,0.167 2.979,0.323 0.313,0.156 10 *a 0.5,0.729 0.813,0.885 0.313,0.156 10 *b 0.49,1.802 0.802,1.958 0.313,0.156 10 *c
*1 Valve
*a Component without harness connected
(Camshaft Timing Oil Control Valve)
*b When applied
*c When cut off


Connect a positive (+) lead from the auxiliary battery to terminal 2 and a negative (-) lead to terminal 1, and check the movement of the valve.

OK:
Condition Specified Condition
Auxiliary battery positive (+) voltage is applied Valve moves in left arrow direction shown in illustration
Auxiliary battery positive (+) voltage is cut off Valve moves in right arrow direction shown in illustration


NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If necessary, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be set.