Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074873 CAMSHAFT OIL CONTROL VALVE G

2AR-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Put the engine in inspection mode (maintenance mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Start the engine.


f.

Inspect the camshaft timing oil control valve assembly.

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the tester.

Standard Condition:
Tester Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:

If the result is not as specified, cool the engine (engine coolant temperature is 50°C (122°F) or less) and perform the Active Test again.