22030
1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
Check that the throttle valve opens and closes smoothly.
Check that there is no sludge accumulated around the throttle with motor body assembly.
| *a | Component without harness connected
(Throttle with Motor Body Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E16-1 (M-) - E16-2 (M+) | 20°C (68°F) | 0.3 to 100 Ω |
If the result is not as specified, replace the throttle with motor body assembly.