Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › THROTTLE BODY
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074874 THROTTLE BODY G

2AR-FXE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY ASSEMBLY

a.

Set the vehicle to inspection mode.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


b.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:
Condition Engine Idle Speed
A/C switched off 900 to 1050 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that park (P) is selected.