Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › MASS AIR FLOW METER
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074876 MASS AIR FLOW METER G

2AR-FXE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A190679
0.754,2.144 1.355,0.719 1.355,0.719 1.43,0.719 false 1.462,0.636 1.638,0.79 0.176,0.154 10 *1
*1 Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.



b.

Check the intake air temperature sensor (built into the mass air flow meter sub-assembly).

i.
A196153
0.396,1.188 0.823,1.448 0.427,0.26 1.917,1.427 2.052,1.885 2.052,1.885 2.135,1.885 false 2.135,1.323 2.458,1.063 2.458,1.063 2.583,1.063 false 0.302,0.188 0.521,0.438 0.219,0.25 10 false *a 2.177,1.813 2.385,1.99 0.208,0.177 10 false E2 2.646,0.969 2.958,1.125 0.313,0.156 10 false THA 0.479,1.229 0.76,1.51 0.281,0.281 10 false E14
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E14-1 (THA) - E14-2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
E14-1 (THA) - E14-2 (E2) 20°C (68°F) 2.21 to 2.69 kΩ
E14-1 (THA) - E14-2 (E2) 60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the mass air flow meter sub-assembly.