Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2012.02–2015.04
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074878 CRANKSHAFT POSITION SENSOR A

2AR-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Clean and degrease the threads of the bolt for the crankshaft position sensor.


b.
A157503
2.177,0.267 2.663,0.449 0.487,0.183 10 *1 2.144,0.353 2.026,0.353 2.026,0.353 1.831,0.841 false
*1 O-ring


Apply a light coat of engine oil to the O-ring of the sensor.


c.
A192239
1.487,1.802 1.645,1.955 0.158,0.153 10 *1 1.887,1.584 1.805,1.887 1.805,1.887 1.686,1.887 false
*1 Adhesive


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



d.

Install the sensor with the bolt.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or moved out of place during installation.



e.

Connect the sensor connector.


Hide 2.INSPECT FOR OIL LEAK