Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074882 AIR FUEL RATIO SENSOR G

2AR-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSPECTION  


PROCEDURE

Hide 89467B 1.INSPECT AIR FUEL RATIO SENSOR

a.
A183494
0.604,1.25 0.938,1.469 0.333,0.219 1.948,1.115 2.25,0.646 2.25,0.646 2.406,0.646 false 1.479,1.104 1.198,0.656 1.198,0.656 1.042,0.656 false 1.469,1.656 1.177,1.844 1.177,1.844 1.042,1.844 false 0.802,0.594 1.073,0.865 0.271,0.271 10 false +B 2.469,0.594 2.958,0.844 0.49,0.25 10 false HA1A 0.667,1.781 1.063,2.042 0.396,0.26 10 false A1A- 1.635,0.302 1.948,0.458 0.313,0.156 10 false *a 0.646,1.281 1.01,1.563 0.365,0.281 10 false E19
*a Component without harness connected
(Air Fuel Ratio Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E19-1 (HA1A) - E19-2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
E19-1 (HA1A) - E19-4 (A1A-) Always 10 kΩ or higher


If the result is not as specified, replace the air fuel ratio sensor.