Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074883 HEATED OXYGEN SENSOR A

2AR-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A255134C01
2.323,0.563 1.281,0.406 1.281,0.406 2.385,1.563 false 0.99,0.333 1.385,0.563 0.396,0.229 10 SST 2.646,0.781 2.958,0.938 0.313,0.156 10 *a 1.927,2.76 2.24,2.917 0.313,0.156 10 *b
*a Fulcrum Length
30 mm
*b Fulcrum Length
300 mm


Using SST, install the heated oxygen sensor to the front exhaust pipe.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:
·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.81 in.).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

The "with SST" torque value is effective when SST is parallel to the torque wrench.




b.

Connect the heated oxygen sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK