Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0A0F-204  Engine Failed to Start  P0A0F-205  Engine Failed to Start  P0A0F-206  Engine Failed to Start  P0A0F-524  Engine Failed to Start  P0A0F-525  Engine Failed to Start  


DESCRIPTION

If an engine malfunction occurs, an engine malfunction signal is sent from the ECM to the power management control ECU. When the power management control ECU receives this signal, it sets a DTC and performs fail-safe control.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0A0F-204 Engine Failed to Start Signal indicating abnormality input from the ECM (abnormal engine output)
·

SFI system

·

Power management control ECU


Does not come on Master Warning Light:
Comes on
P0A0F-205 Engine Failed to Start Signal indicating abnormality input from the ECM (engine is unable to start)
·

SFI system

·

Power management control ECU


Does not come on Master Warning Light:
Comes on
P0A0F-206 Engine Failed to Start Signal indicating abnormality input from the ECM (engine component malfunction)
·

SFI system

·

Power management control ECU


Does not come on Master Warning Light:
Comes on
P0A0F-524 Engine Failed to Start Signal indicating abnormality input from the ECM (NE signal error)
·

SFI system

·

Power management control ECU


Does not come on Master Warning Light:
Comes on
P0A0F-525 Engine Failed to Start Signal indicating abnormality input from the ECM (GI signal error)
·

SFI system

·

Power management control ECU


Does not come on Master Warning Light:
Comes on

PROCEDURE

1.CHECK DTC OUTPUT (ENGINE AND ECT)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Check if DTCs are output.

Result:
Result Proceed to
SFI system DTCs are not output. A
SFI system DTCs are output. B


HINT:

If P0A0F-204, 205, 206, 524, or 525 is output even though the ECM has not detected a malfunction, there is a malfunction in the power management control ECU.



e.

Turn the power switch off.



A

B