The MG ECU uses a voltage sensor that is built into the boost converter to detect pre-boost high voltage (VL) to allow boost control. The MG ECU monitors the boost converter voltage sensor signal line and detects the following malfunctions.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P0A94-589 | DC / DC Converter Performance | Open or short to GND in the boost converter voltage (VL) sensor circuit | Inverter with converter assembly | Comes on | Master Warning Light:
Comes on |
| P0A94-590 | DC / DC Converter Performance | Short to +B in the boost converter voltage (VL) sensor circuit | Inverter with converter assembly | Comes on | Master Warning Light:
Comes on |
(Click here Engine / Hybrid System>HYBRID / BATTERY CONTROL>INVERTER WITH CONVERTER>COMPONENTS)
The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly. If P0A94-589 or P0A94-590 is output, replace the inverter with converter assembly.
| Proceed to |
|---|
| NEXT |
NEXT