Refer to the description for DTC P0705-757 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>P0705-757).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P0705-758 | Transmission Range Sensor Circuit | Shifting malfunction (open circuit in MJ) | ·
Wire harness or connector ·
Shift lever position sensor ·
Power management control ECU |
Does not come on | Master Warning Light:
Comes on |
Refer to the wiring diagram for DTC P0705-757 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>P0705-757).
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P0705-758 only is output. | A |
| P0705-757 is also output. | B |
Turn the power switch off.
A
B
Turn the power switch on (IG).
| *a | Component with harness connected
(Power Management Control ECU) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-16 (MJ) - Body ground | Power switch on (IG)
Shift lever in P, R, N, D, or B |
11 to 14 V |
Turn the power switch off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>P0705-757
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the shift lever position sensor connector.
| *a | Component without harness connected
(Shift Lever Position Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E11-8 (+B) - E11-5 (MJ) | Shift lever in P, R, N, D, or B | Below 1 Ω |
Connect the shift lever position sensor connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG