Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P06A4-209  Sensor Reference Voltage "D" Circuit Low  P06A5-210  Sensor Reference Voltage "D" Circuit High  


DESCRIPTION

The power management control ECU monitors voltage of 5 V power supply (VC) used for the sensors. If the power management control ECU detects a malfunction, it will set a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P06A4-209 Sensor Reference Voltage "D" Circuit Low VC power-supply voltage is lower than 4.2 V Power management control ECU Does not come on Master Warning Light:
Comes on
P06A5-210 Sensor Reference Voltage "D" Circuit High VC power-supply voltage is higher than 5.8 V Power management control ECU Does not come on Master Warning Light:
Comes on

PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / DTC.

Powertrain > Hybrid Control > Trouble Codes
50001 236

d.

Check if DTCs are output.

Result:
Result Proceed to
P06A4-209 to P06A5-210 only is output. A
Any of the following DTCs are also output. B


DTC No. Relevant Diagnosis
P0516-769 Battery Temperature Sensor Circuit Low
P0517-770 Battery Temperature Sensor Circuit High
P0A2C-247 Drive Motor "A" Temperature Sensor Circuit Low
P0A2D-249 Drive Motor "A" Temperature Sensor Circuit High
P0A38-257 Generator Temperature Sensor Circuit Low
P0A39-259 Generator Temperature Sensor Circuit High
P2120-152 Throttle / Pedal Position Sensor / Switch "D" Circuit
P2122-104 Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input
P2123-105 Throttle / Pedal Position Sensor / Switch "D" Circuit High Input
P2125-153 Throttle / Pedal Position Sensor / Switch "E" Circuit
P2127-107 Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input
P2128-108 Throttle / Pedal Position Sensor / Switch "E" Circuit High Input

HINT:

P06A4-209 or P06A5-210 may be set due to a malfunction which also causes DTCs in the preceding table to be set. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.



e.

Turn the power switch off.



A

B