Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P321F-319  Part of HV Gate Blocking Range/Performance  


DESCRIPTION

Refer to the description for DTC P321E-318 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>P321E-318).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P321F-319 Part of HV Gate Blocking Range/Performance
·

An open or ground short in the HV gate block signal circuit when the gate is operating

·

When the HV gate block function is being checked, inverter voltage (VH) drops or current flows in the inverter. (Either the motor (MG2) or the generator (MG1) is malfunctioning.)


Inverter with converter assembly Does not come on Master Warning Light:
Comes on

PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / DTC.


d.

Check if DTCs are output.

Powertrain > Hybrid Control > Trouble Codes
50001 236
Result:
Result Proceed to
P321E-318 is not output. A
P321E-318 is also output. B



e.

Turn the power switch off.



A

B