The power management control ECU receives a signal that indicates a collision from the airbag sensor assembly to detect a collision. After detecting a collision, the power management control ECU shuts off the high voltage systems for safety.
If P1606-308 or 317 is output, the vehicle cannot start unless the DTCs are cleared using the intelligent tester.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P1606-308 | Collision has been detected or Collision Sensor Connection (Open) | Shutoff signal from the airbag sensor assembly is determined. | ·
Airbag sensor assembly ·
Power management control ECU ·
Supplemental restraint systems |
Does not come on | Master Warning Light:
Comes on |
| P1606-317 | Collision has been detected or Collision Sensor Connection (Open) | A collision is determined due to a wiring malfunction. | ·
Power management control ECU ·
Supplemental restraint systems |
Does not come on | Master Warning Light:
Comes on |
Check the vehicle condition.
| Result | Proceed to |
|---|---|
| The vehicle is not damaged. | A |
| The vehicle is damaged. | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P1606 only is output. | A |
| P0A1D is output. | B |
Turn the power switch off.
A
B
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Troubleshoot the airbag system.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| The system is normal. | A |
| There is a malfunction in the system. | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Access the freeze frame data of DTC P1606 and read the INF code.
| Result | Proceed to |
|---|---|
| INF code 308 is output. | A |
| INF code 317 is output. | B |
Turn the power switch off.
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| One or two of the following conditions are met. | A |
| All of the following conditions are met. | B |
| DTC Output Status |
|---|
| P3107-213 or P3107-214 is output. |
| U0151-763 is output. |
| U0110-160 or U0110-657 is output. |
Turn the power switch off.
A
B
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART