Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P3000-603  Battery Control System  


DESCRIPTION

The power management control ECU monitors its internal operation and detects the following malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P3000-603 Battery Control System The power management control ECU detects a HV battery cooling system error signal.
·

Power management control ECU

·

HV battery


Does not come on Master Warning Light:
Comes on

CAUTION / NOTICE / HINT

CAUTION:

When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.


PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / DTC.

Powertrain > Hybrid Control > Trouble Codes
50001 236

d.

Check if DTCs are output.

Result:
Result Proceed to
P3000-603 only is output. A
DTCs other than P3000-603 are also output. B



e.

Turn the power switch off.



A

2.REPLACE POWER MANAGEMENT CONTROL ECU

B

2.REPLACE POWER MANAGEMENT CONTROL ECU

NEXT