CHECK FOR DTCS
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check the DTCs and freeze frame data, and then write them down.
Check the details of the DTCs (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CHECK FREEZE FRAME DATA AND INFORMATION
If a DTC is present, select it in order to display its freeze frame data.
Read the freeze frame data recorded when the DTC was set.
A 3-digit information code (INF code) will be displayed as the value for one of the Information 1 to Information 5 lines.
Read the information for the information code.
Select the item from among Information 1 to Information 5 that has an information code and click the engine icon to view the additional information.
CHECK FOR DTCS (SYSTEMS OTHER THAN POWER MANAGEMENT CONTROL ECU)
The power management control ECU maintains communication with other computers, including the ECM, skid control ECU and power steering ECU. Therefore, if the power management control ECU outputs a warning, it is necessary to check and record the DTCs of all systems.
If DTCs are present, check the relevant systems.
If DTCs for the CAN communication system are present in addition to other DTCs, first troubleshoot and repair any malfunctions in the CAN communication system.
CLEAR DTCS
Clearing the DTCs will also clear the freeze frame data, information (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>FREEZE FRAME DATA), and operation history data (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>OPERATION HISTORY DATA).
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Check that park (P) is selected.
Enter the following menus: Powertrain / Hybrid Control / DTC.
Clear DTCs and freeze frame data.