Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › RELAY
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074895 RELAY G

HYBRID / BATTERY CONTROL  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85924 1.INSPECT IGNITION CONTROL RELAY (IGCT)

a.
A253297
0.165,0.068 0.398,0.266 0.233,0.198 10 *1
*1 Ignition Control Relay


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage is not applied across terminals 1 and 2 10 kΩ or higher
3 - 5 Auxiliary battery voltage is applied across terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.


Hide G9020E 2.INSPECT HYBRID WATER PUMP RELAY (INV W/PMP)

a.
E222294
1.094,0.948 1.292,0.5 1.292,0.5 1.427,0.5 false 1.052,1.344 1.135,1.76 1.135,1.76 1.333,1.76 false 0.792,0.99 0.906,0.5 0.906,0.5 1.031,0.5 false 0.552,1.271 0.625,1.75 0.625,1.75 0.813,1.75 false 1.458,0.406 1.563,0.563 0.104,0.156 10 false 1 1.375,1.667 1.479,1.823 0.104,0.156 10 false 2 1.094,0.396 1.198,0.552 0.104,0.156 10 false 5 0.844,1.667 0.948,1.823 0.104,0.156 10 false 3 0.073,0.052 0.302,0.229 0.229,0.177 10 false *1
*1 Hybrid Water Pump Relay


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage is not applied across terminals 1 and 2 10 kΩ or higher
3 - 5 Auxiliary battery voltage is applied across terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.