Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › COMBINATION SWITCH
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074897 COMBINATION SWITCH G

HYBRID / BATTERY CONTROL  COMBINATION SWITCH  INSPECTION  


PROCEDURE

Hide 84720J 1.INSPECT EV DRIVE MODE SWITCH (PATTERN SELECT SWITCH ASSEMBLY)

a.
A259195
0.448,0.938 0.906,1.219 0.458,0.281 1.094,1.688 1.396,1.24 false 2.333,1.688 2.031,1.24 false 0.25,0.188 0.438,0.354 0.188,0.167 10 false *a 0.573,0.99 0.802,1.156 0.229,0.167 10 false I48 1,1.719 1.115,1.885 0.115,0.167 10 false S 2.333,1.719 2.448,1.885 0.115,0.167 10 false E
*a Component without harness connected
(EV Drive Mode Switch (Pattern Select Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I48-4 (S) - I48-1 (E) EV drive mode switch (pattern select switch assembly). being pushed and held Below 1 Ω
I48-4 (S) - I48-1 (E) EV drive mode switch (pattern select switch assembly). not pushed 10 kΩ or higher


If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).


b.
A259195
0.448,0.938 0.906,1.219 0.458,0.281 1.25,1.719 1.583,1.24 false 2.323,1.74 1.865,1.229 false 0.25,0.188 0.438,0.354 0.188,0.167 10 false *a 0.573,0.99 0.896,1.156 0.323,0.167 10 false I48 1.104,1.75 1.427,1.917 0.323,0.167 10 false ILL+ 2.25,1.771 2.573,1.938 0.323,0.167 10 false ILL-
*a Component without harness connected
(EV Drive Mode Switch (Pattern Select Switch Assembly))


Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch (pattern select switch assembly).

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → I48-3 (ILL+) Auxiliary battery negative (-) →I48-2 (ILL-) Illuminates


If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).