Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL PUMP
RM2040EQ _51 Engine / Hybrid System _014694 2AR-FXE FUEL _0074912 FUEL PUMP G

2AR-FXE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A192531
1.604,0.583 1.365,1.073 false 1.823,0.594 2.063,1.083 false 1.292,1.063 1.51,1.281 0.219,0.219 10 false 1 2.104,1.094 2.323,1.313 0.219,0.219 10 false 2

Check the fuel pump resistance.

i.

Using an ohmmeter, measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check fuel pump operation.

i.

Apply battery voltage to terminals 1 and 2. Check that the pump operates.

NOTICE:
·

These tests must be done quickly (within 10 seconds) to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always switch the voltage on and off at the battery side, not the fuel pump side.



If the pump does not operate, replace the fuel pump.