Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL PUMP
RM2040EQ _51 Engine / Hybrid System _014694 2AR-FXE FUEL _0074912 FUEL PUMP A

2AR-FXE FUEL  FUEL PUMP  REASSEMBLY  


PROCEDURE

Hide 23221 1.INSTALL FUEL PUMP

a.
A192863
2.063,0.594 2.281,0.385 2.281,0.385 2.365,0.385 false 2.063,0.792 2.365,0.792 false 2.417,0.313 2.583,0.479 0.167,0.167 10 *1 2.406,0.708 2.604,0.885 0.198,0.177 10 *2
*1 O-ring
*2 Fuel Pump Spacer


Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.


b.
A136240
0.619,0.169 0.789,0.339 0.17,0.17 10 *1 2.961,1.706 3.156,1.942 0.194,0.236 10 *2 3.042,1.422 3.042,1.706 false 1.136,0.26 0.805,0.26 false
*1 Fuel Filter
*2 Suction Filter


Engage the 5 claws on the fuel filter and install the fuel pump with the suction filter.

NOTICE:
·

Make sure that the O-ring is not cut or pinched during the installation.

·

Engage the claws securely.

·

Do not remove the suction filter.



HINT:

Perform "Inspection After Repair" after replacing the fuel pump.

Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.
A255955

Engage the 2 claws of the No. 1 fuel suction support.


d.

Connect the fuel pump harness connector to the fuel pump.


e.

Install the spring to the fuel suction plate shaft and install it to the lower fuel tank case sub-assembly.


f.
A211201

Engage the 4 claws of the No. 1 fuel suction support and install the lower fuel tank case sub-assembly to the fuel suction plate with the fuel filter.


g.

Install a new E-ring.


h.

Connect the fuel pump harness connectors to the fuel suction plate.


Hide 83320 2.INSTALL FUEL SENDER GAUGE ASSEMBLY