Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › CANISTER
RM2040EQ _51 Engine / Hybrid System _014695 2AR-FXE EMISSION CONTROL _0074919 CANISTER G

2AR-FXE EMISSION CONTROL  CANISTER  INSPECTION  


PROCEDURE

Hide 77740 1.INSPECT CHARCOAL CANISTER ASSEMBLY

a.

Visually check the charcoal canister.

i.

Visually check the charcoal canister for cracks or damage.

HINT:

If cracks or damage are found, replace the charcoal canister assembly.




b.

Check charcoal canister airflow.

i.
A255922
1.344,1.063 0.802,1.063 true 1.771,1.156 1.177,0.385 1.177,0.385 0.938,0.385 true 2.271,0.781 2.667,0.781 true 0.646,0.99 0.865,1.208 0.219,0.219 10 false *a 0.76,0.302 1.021,0.531 0.26,0.229 10 false *b 2.74,0.688 3,0.938 0.26,0.25 10 false *c
*a Port A
*b Port B
*c Port C


Using a vacuum pump, check that air flows through the canister according to the instructions below.

Standard:
Measurement Condition Specified Condition
Block port B and C and apply 2 kPa (15 mmHg, 0.591 in.Hg) of vacuum into port A. There are no leaks.
Block port B and apply 2 kPa (15 mmHg, 0.591 in.Hg) of vacuum into port A. Air is sucked into port C
Block port C and blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into port A. Air comes out of port B.
Blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into port A. Air comes out of port B and C.


HINT:

If the standard is not as specified, replace the charcoal canister assembly.




Hide 77740 2.CLEAN FILTER IN CANISTER

a.
A256493
1.354,1.156 0.875,1.156 false 1.74,1.25 1.063,1.792 1.063,1.792 0.854,1.792 false 0.698,1.083 0.958,1.271 0.26,0.188 10 false *a 0.688,1.719 1.01,1.969 0.323,0.25 10 false *b 1.135,0.354 1.344,0.552 0.208,0.198 10 false *c
*a Port A
*b Port B
*c Air


Clean the filter by blowing 5 kPa (0.1 kgf/cm2, 0.7 psi) of compressed air into port A while holding port B closed.

NOTICE:
·

Make sure to clean the filter using only air, do not use gasoline or any other means.

·

Do not disassemble the charcoal canister assembly.