Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › PURGE VALVE
RM2040EQ _51 Engine / Hybrid System _014695 2AR-FXE EMISSION CONTROL _0074920 PURGE VALVE G

2AR-FXE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25804A 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge VSV.


b.
A258673
1.427,1.146 0.875,1.146 false 1.156,1.625 0.74,1.625 false 0.563,1.542 0.885,1.771 0.323,0.229 10 false *b 0.698,1.063 1.042,1.344 0.344,0.281 10 false *a 1.094,0.094 1.802,0.542 0.708,0.448 10 false *c
*a Port E
*b Port F
*c Air


Apply auxiliary battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

OK:
Measurement Condition Specified Condition
Auxiliary battery voltage applied between terminals 1 and 2 Air flows from port F
Auxiliary battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge VSV.