Home › Engine / Hybrid System › 2AR-FXE LUBRICATION › LUBRICATION SYSTEM
RM2040EQ _51 Engine / Hybrid System _014698 2AR-FXE LUBRICATION _0074937 LUBRICATION SYSTEM G

2AR-FXE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL LEVEL

a.

Put the engine in inspection mode.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


b.

Warm up and stop the engine, and then wait 5 minutes.


c.

Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.

If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill the engine with oil to above the full level mark.



Hide 2.INSPECT ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.


Hide 3.INSPECT OIL PRESSURE

a.

Remove the oil pressure switch assembly.

Click hereEngine / Hybrid System>2AR-FXE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL


b.
A209392C05
1.469,0.563 0.833,0.563 true 1.479,0.479 1.656,0.646 0.177,0.167 10 true *1
*1 Oil Pressure Gauge


Install an oil pressure gauge with the adapter.


c.

Put the engine in inspection mode.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


d.

Warm up the engine.


e.

Measure the oil pressure.

Standard Oil Pressure:
Condition Engine Oil Temperature Specified Condition
1000 rpm 80°C (176°F) 145 kPa (1.5 kgf/cm2, 21 psi)
2500 rpm 340 kPa (3.5 kgf/cm2, 49 psi)



f.

Remove the oil pressure gauge with the adapter.


g.

Install the oil pressure switch assembly.

Click hereEngine / Hybrid System>2AR-FXE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION