Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE SYSTEM
RM2040EQ _52 Drivetrain _014701 P314 HYBRID TRANSMISSION / TRANSAXLE _0074943 HYBRID TRANSAXLE SYSTEM G

P314 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FLUID PRESSURE OF OIL PUMP

NOTICE:

Do the test at normal operating fluid temperature of 50 to 80°C (122 to 176°F).


a.

Remove the front fender apron seal LH.


b.
C141372

Remove the fluid pump cover plug and O-ring from the hybrid vehicle transaxle assembly.


c.
C245073N01
2.906,0.948 2.906,1.427 true 0.74,0.885 1.135,0.885 true 2.781,1.458 3.094,1.646 0.313,0.188 10 false SST 1.177,0.802 1.49,0.969 0.313,0.167 10 true SST

Install SST to the hybrid vehicle transaxle assembly.

SST
09992-00095  (09992-00112, 09992-00271)


d.

Put the engine in inspection mode.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Measure the fluid pressure.

Standard:
Engine Speed Transaxle Fluid Pressure
900 rpm 9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more


NOTICE:

Be sure to cancel the inspection mode immediately after the transaxle fluid pressure check is completed.



f.

Remove SST from the hybrid vehicle transaxle assembly.


g.

Install a new O-ring and fluid pump cover plug to the hybrid vehicle transaxle assembly.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


h.

Install the front fender apron seal LH.