Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE FLUID
RM2040EQ _52 Drivetrain _014701 P314 HYBRID TRANSMISSION / TRANSAXLE _0074947 HYBRID TRANSAXLE FLUID A

P314 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE HYBRID TRANSAXLE FLUID

a.

Be sure that the vehicle remains level and lift the vehicle. [*1]


b.
C243608C03
0.854,1.396 0.74,1.156 0.74,1.156 0.448,1.156 true 1.083,1.875 0.542,1.875 true 0.271,1.083 0.427,1.229 0.156,0.146 10 false *1 0.354,1.802 0.51,1.969 0.156,0.167 10 false *2
*1 Filler Plug
*2 Drain Plug


Using a 10 mm hexagon socket wrench, remove the filler plug and gasket. [*2]


c.

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket to drain the hybrid transaxle fluid. [*3]


d.

Using a 10 mm hexagon socket wrench, temporarily install the drain plug and gasket. [*4]

HINT:

Because the drain plug will be removed again, the gasket can be reused at this time.



e.
C243609C03
2.146,1.052 2.271,0.708 2.271,0.708 2.365,0.708 false 0.688,1.448 0.313,1.448 true 2.396,0.625 2.552,0.771 0.156,0.146 10 false *1 0.156,1.375 0.313,1.521 0.156,0.146 10 false *2
*1 Filler Nozzle
*2 Filler Plug


Add transaxle fluid until the fluid level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the filler plug opening. [*5]

NOTICE:
·

Use Toyota Genuine ATF WS.

·

Be sure to fully insert the filler nozzle into the filler plug opening.

·

Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

·

Be sure to directly check that the transaxle fluid level is within the specified range.

·

Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.




f.

Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket. [*6]

HINT:

Because the filler plug will be removed again, the gasket can be reused at this time.



g.

Lower the vehicle. [*7]


h.

Connect the intelligent tester to the DLC3 and turn the power switch on (IG). [*8]


i.

Put the engine in inspection mode. [*9]

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


j.

Idle the engine for 30 seconds with the power switch on (READY). [*10]


k.

Turn the power switch off. [*11]


l.

Repeat steps [*1] to [*11].


m.

Repeat steps [*1] to [*3].


n.

Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.

Torque:
39 N*m (400 kgf*cm, 29 ft.*lbf)