Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE
RM2040EQ _52 Drivetrain _014701 P314 HYBRID TRANSMISSION / TRANSAXLE _0074948 TRANSMISSION CONTROL CABLE N

P314 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  ADJUSTMENT  


PROCEDURE

Hide 1.INSPECT SHIFT LEVER POSITION

a.

While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.


b.

Put the vehicle into the READY-on state and check the following:

i.

When the shift lever is moved to D, the vehicle moves forward.


ii.

When the shift lever is moved to R, the vehicle moves in reverse.

NOTICE:

The vehicle should not move when the shift position indicator is off.




Hide 2.ADJUST SHIFT LEVER POSITION

a.

Move the shift lever to N.


b.

Remove the rear console box assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL


c.
C244759

Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.


d.
C194520C19
2.25,2.573 2.594,2.573 false 1.958,1.75 2.094,1.531 2.094,1.531 2.198,1.531 false 1.635,0.906 1.823,1.083 0.188,0.177 10 true *a 1.792,1.365 1.979,1.542 0.188,0.177 10 false *a 2.469,0.875 2.656,1.052 0.188,0.177 10 false *b 2.229,1.458 2.417,1.635 0.188,0.177 10 false *1 2.229,2.333 2.417,2.51 0.188,0.177 10 false *b 2.615,2.49 2.802,2.667 0.188,0.177 10 false *2
*1 Slider
*2 Lock Piece
*a Slide
*b Pull


Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.


e.
C241614C05
1.281,2.24 1.406,2.042 1.406,2.042 1.542,2.042 false 1.583,1.958 1.875,2.146 0.292,0.188 10 false *1
*1 Lock Piece


Install the end of the transmission control cable assembly to the lower shift lever assembly.

NOTICE:
·

Check that the lock piece is pulled up.

·

Install the cable end all the way to the base of the pin.




f.

Push the lock piece into the adjuster case.

NOTICE:
·

Check that the park/neutral position switch and the shift lever are in neutral.

·

Securely push in the lock piece until the slider lock is engaged.




g.

After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.


h.

Install the rear console box assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION