Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM2040EQ _53 Suspension _014706 REAR SUSPENSION _0074974 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48840A 1.INSPECT REAR STABILIZER LINK ASSEMBLY

a.
C066721

Inspect the turning torque of the ball joint.

i.

Secure the rear stabilizer link assembly in a vise using aluminum plates.


ii.

Install the nut to the rear stabilizer link assembly stud.


iii.

Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Turning torque:

0.05 to 1.0 N*m (0.5 to 10 kgf*cm, 0.4 to 8.7 in.*lbf)


If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.

If there is any abnormality, replace the rear stabilizer link assembly with a new one.