Home › Suspension › REAR SUSPENSION › REAR STRUT ROD
RM2040EQ _53 Suspension _014706 REAR SUSPENSION _0074976 REAR STRUT ROD A

REAR SUSPENSION  REAR STRUT ROD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58399B 2.REMOVE NO. 2 FLOOR UNDER COVER

a.
C253281
0.323,2.094 0.344,2.094 false
V100135

Nut (attached to under cover)


Remove the 2 clips.


b.

Disengage the 6 nuts and remove the No. 2 floor under cover.

HINT:

The 6 nuts will remain attached to the No. 2 floor under cover.



Hide 58398H 3.REMOVE NO. 1 FLOOR UNDER COVER (for RH Side)

a.
C253280
2.677,0.115 2.688,0.094 false
V100135

Nut (attached to under cover)


Disengage the 6 nuts, and remove the No. 1 floor under cover.

HINT:

The 6 nuts will remain attached to the No. 1 floor under cover.



Hide 46430 4.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.
C240545

Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.


Hide 48780A 5.REMOVE REAR STRUT ROD ASSEMBLY

a.
C241287
1.198,2.073 1.198,1.802 1.198,1.802 0.927,1.802 false 2.25,1.656 2.708,1.656 false 2.281,4.063 2.281,4.406 false 0.76,1.719 1.052,1.948 0.292,0.229 10 false *1 2.74,1.573 2.979,1.813 0.24,0.24 10 false *2 2.198,4.427 2.406,4.646 0.208,0.219 10 false *2
*1 Jack
*2 Wooden Block


Support the rear axle carrier sub-assembly with a jack using a wooden block.


b.
C132475

Remove the bolt and nut, and separate the rear strut rod assembly (front side).

NOTICE:

When removing the bolt, keep the nut from rotating.



c.
C132476

Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.

NOTICE:

When removing the bolt, keep the nut from rotating.