Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY
RM2040EQ _54 Brake _014708 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074979 RELAY G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 88263P 1.INSPECT STOP LIGHT CONTROL RELAY (STOP RELAY)

a.
C223784
2.719,1.417 2.719,0.865 2.719,0.865 2.76,0.865 false 2.427,1.906 2.427,1.635 2.427,1.635 1.99,1.635 false 2.281,2.542 2.281,2.833 2.281,2.833 2.229,2.833 false 2.573,2.552 2.573,3.021 2.573,3.021 2.5,3.021 false 2.833,2.542 2.833,3.021 2.833,3.021 2.875,3.021 false 0.281,0.25 0.531,0.448 0.25,0.198 10 false *1 1.885,1.563 2.083,1.76 0.198,0.198 10 false 5 2.896,2.938 3.094,3.146 0.198,0.208 10 false 1 2.125,2.76 2.333,2.99 0.208,0.229 10 false 2 2.792,0.781 2.979,0.979 0.188,0.198 10 false 3 2.406,2.948 2.604,3.146 0.198,0.198 10 false 4
*1 Stop Light Control Relay (STOP Relay)


Remove the stop light control relay (STOP relay).


b.

Check both the relay case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Voltage is not applied between terminals 1 and 2 Below 1 Ω
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 4 Voltage is applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the stop light control relay (STOP relay).